STNRG388A

概述

样片和购买

解决方案

文件

CAD资源

工具与软件

质量与可靠性

开始

Partner products

銷售公文包

Please enter your desired search query and search again

产品概述

所有功能
Up to 6 programmable PWM generators (SMED - “State Machine Event Driven”)

10 ns event detection and reaction

Max.1.3 ns PWM resolution

Single, coupled and two coupled operational modes

Up to 3 internal/external events per SMED

4 analog comparators

4 internal 4-bit references

Up to 4 external references

Less than 50 ns propagation time

Continuous comparison cycle

Configurable hysteresis voltage levels

ADCs (up to 8 channels)

10-bit precision, with operational amplifier to extend resolution to 12-bit equivalent

Sequencer functionality

Input impedance: 1 MW

Configurable gain value: x1 and x4

Integrated microcontroller

Advanced STM8^® core with Harvard architecture and 3-stage pipeline

Max. f_CPU: 16 MHz

存储器

Flash and E²PROM with read while write (RWW) and error correction code (ECC)

Program memory: 32 Kbytes Flash; data retention 15 years at 85 °C after 10 kcycles at 25 °C

Data memory: 1 Kbyte true data E²PROM; data retention:15 years at 85 °C after 100 kcycles at 85 °C

RAM: 6 Kbytes

Clock management

Internal 96 MHz PLL

Low power oscillator circuit for external crystal resonator or direct clock input

Internal, user-trimmable 16 MHz RC and low power 153.6 kHz RC oscillators

Clock security system with clock monitor

Basic peripherals

System, auxiliary and basic timers

IWDG/WWDG watchdog, AWU, ITC

Reset and supply management

Multiple low power modes (wait, slow, auto- wakeup, Halt) with user definable clock gating

Low consumption power-on and power- down reset

I/O

Multifunction bidirectional GPIO with highly robust design, immune against current injection

Fast digital input DIGIN, with configurable pull-up

Communication interfaces

UART asynchronous with SW flow control and bootloader support

I²C master/slave fast-slow speed rate

Operating temperature: -40 °C up to 105 °C.

Configurable state machine generating a PWM signal

More than 10.4 ns PWM native resolution
Up to 1.3 ns PWM resolution when using SMED dithering

6 states available in each SMED: IDLE, S0, S1, S2, S3 plus a special HOLD state

Transactions triggered by synchronous and asynchronous external events or an internal timer

Each transaction can generate an interrupt

Fifteen registers available to configure the state machine behavior

Four 16-bit configurable time registers, one for each running state (T0, T1, T2, T3)

Internal resources accessible through the processor interface

Eight interrupt request lines

Configurable ADC HW trigger request

PWM pseudo open drain features configurable through GPIO1 registers

GPIO0 [x] configured as input Hiz (where x = 1,0)

DAC&x>_EN = '0' and CP&x>_EN_ERef = '1 of MSC_DACCTR available only &undefined&undefinedon the STNRG388A register.
阅读更多阅读较少信息