L4984D

批量生产
Design Win
储存到myST

CCM PFC控制器

下载数据手册
Order Direct

产品概述

描述

The L4984D is a current-mode PFC controller operating with line-modulated fixed-off-time (LM-FOT) control. A proprietary LM-FOT modulator allows fixed-frequency operation for boost PFC converters as long as they are operated in CCM (continuous conduction mode).

The chip comes in a 10-pin SO package and offers a low-cost solution for CCM-operated boost PFC pre-regulators in EN61000-3-2 and JEIDA-MITI compliant applications, in a power range that spans from few hundred W to 1 KW and above.

The highly linear multiplier includes a special circuit, able to reduce the crossover distortion of the AC input current, that allows wide-range-mains operation with a reasonably low THD, even over a large load range.

The output voltage is controlled by means of a voltage-mode error amplifier and an accurate (1% at Tj = 25 °C) internal voltage reference. Loop stability is optimized by the voltage feedforward function (1/V2correction), which in this IC uses a proprietary technique that also significantly improves line transient response in the case of mains drops and surges (“bi-directional”).

The device features low consumption and includes a disable function suitable for IC remote on/off. These features allow use in applications which also comply with the latest energy saving requirements (Blue Angel, ENERGY STAR, Energy 2000, etc.).

In addition to overvoltage protection able to keep the output voltage under control during transient conditions, the IC is also provided with protection against feedback loop failures or erroneous settings. Other onboard protection functions allow that brownout conditions and boost inductor saturation can be safely handled. Soft-start limits peak current and extends off-time to prevent flux runaway in the initial cycles.

The totem pole output stage, capable of 600 mA source and 800 mA sink current, is suitable for big MOSFETs or IGBT drive.

  • 所有功能

    • Line-modulated fixed-off-time (LM-FOT) control of CCM-operated PFC pre-regulators
    • Proprietary LM-FOT modulator for nearly fixed-frequency operation
    • Proprietary multiplier design for minimum THD of AC input current
    • Fast “bi-directional” input voltage feedforward (1/V2correction)
    • Accurate adjustable output overvoltage protection
    • Protection against feedback loop failure (latched shutdown)
    • Inductor saturation protection
    • AC brownout detection
    • Digital leading-edge blanking on current sense
    • Soft-start
    • 1% (at Tj = 25 °C) internal reference voltage
    • - 600 / + 800 mA totem pole gate driver with active pull-down during UVLO and voltage clamp
    • SSOP10 package
    阅读更多 阅读较少信息

eDesignSuite

eDesignSuite is a comprehensive set of easy-to-use design-aid utilities ready to help you streamline the system development process with a wide range of ST products.

Power Management Design Center

Thermal-electrical Simulators for Components

Signal Conditioning Design Tool

NFC/RFID Calculators

Choose design tool:
Power Management Design Center

Power Supply Design Tool

• SMPS design, by topology, by type and by product
• PFC design with analog and digitial control
• Supports various PCB configurations
Choose type:
DC/DC
AC/DC
太阳能电池充电器
Power Management Design Center

LED Lighting Design Tool

• Handles AC-DC and DC-DC design in common topologies
• Displays interactive and annotated schematic
• Provides current/voltage graphs, Bode plots, efficiency curves and power-loss data
Choose type:
DC/DC
AC/DC
Power Management Design Center

Digital Power Workbench

• Provides a step-by-step optimized design of power section and control loop
• Generates the STM32Cube embedded software package for custom applications and allows firmware project generation, compatible with multiple STM32 IDEs
Power Management Design Center

Power Tree Designer

• Specify input/output power for each node in the tree
• Check for consistency
• Design each individual node
Choose design tool:
Thermal-electrical Simulators for Components

AC Switches Simulator

• Select ratings and application waveforms
• Get junction temperature and blocking voltage graphs
• Search and sort suitable devices
Thermal-electrical Simulators for Components

Rectifier Diodes Simulator

• Select ratings and application waveforms
• Estimate power losses
• Search and sort suitable devices
Thermal-electrical Simulators for Components

STPOWER Studio

• Supports long mission profiles
• Provides power loss and temperature graphs
• Helps define heatsink thermal properties
Thermal-electrical Simulators for Components

Twister Sim

• Help select the right ViPOWER Automotive power device
• Supports load-compatibility, wiring harness optimization, fault condition impact and diagnostic analysis
• Supports various PCB configurations
Thermal-electrical Simulators for Components

TVS Simulator

• Specify system ratings and surge waveform
• Search and sort suitable devices
Thermal-electrical Simulators for Components

Estimate

• Build simple schematics and firmware inputs in minutes
• Quickly generate reliable estimates of battery life, system power consumption and bill of materials costs
Choose design tool:
Signal Conditioning Design Tool

Active Filters

• Handles multi-stage-designs and common topologies
• Returns circuit component values
• Provides gain, phase and group delay graphs
• Low Pass, High Pass and Band Pass
Signal Conditioning Design Tool

Comparators

• Handles most common configurations
• Returns circuit components values
• Provides I/O signal waveforms
• Inverting, Non Inverting, Window
Signal Conditioning Design Tool

Low side Current Sensing

• Returns circuit component values
• Provides current error graphs
Signal Conditioning Design Tool

High side Current Sensing

• Provides current error graphs.
• Help to select the right High side current sensing and shunt devices.
Choose design tool:
NFC/RFID Calculators

NFC Inductance

• Input geometry and substrate properties
• Get antenna impedance
NFC/RFID Calculators

UHF Link Budget

• Enter forward and reverse link characteristics
• The tool returns link budget estimate
NFC/RFID Calculators

NFC Tuning Circuit

• Enter antenna parameter and matching target
• Select the topology of the matching network
• The tool returns component values for the desired design targets

您可能还会喜欢...

STDES-2KW5CH48V

STDES-2KW5CH48V

EVL4984-350W

基于L4984D的350 W CCM PFC预调节器演示板

特别推荐

EDA符号、封装和3D模型

STMicroelectronics - L4984D

Speed up your design by downloading all the EDA symbols, footprints and 3D models for your application. You have access to a large number of CAD formats to fit with your design toolchain.

Please select one model supplier :

Start your design with UltraLibrarian
Start your design with SamacSys
Symbols

符号

Footprints

封装

3D model

3D模型

质量与可靠性

产品型号 Marketing Status 包 等级规格 符合RoHS级别 材料声明**
L4984D
批量生产
SSOP 10 工业 Ecopack2
L4984DTR
批量生产
SSOP 10 工业 Ecopack2

L4984D

Package:

SSOP 10

Material Declaration**:

PDF XML
More Info

Marketing Status

批量生产

Package

SSOP 10

Grade

Industrial

RoHS Compliance Grade

Ecopack2

L4984DTR

Package:

SSOP 10

Material Declaration**:

PDF XML
More Info

Marketing Status

批量生产

Package

SSOP 10

Grade

Industrial

RoHS Compliance Grade

Ecopack2

(**) st.com上提供的材料声明表单可能是基于包装系列中最常用的封装的通用文档。因此，它们可能不是100%适用于特定的设备。有关特定设备的信息，请联系 销售支持。

样片和购买

(*) 建议转售单价（美元）仅用于预算用途。如需以当地货币计价的报价，请联系您当地的 ST销售办事处 或我们的 经销商。

产品

搜索历史

收藏

Please log in  to show your saved searches.

▼

您知道吗？

Please provide email

Please enter code

Congratulations!

Simple subscription

Congratulations!

x

您可以开始跟踪此产品，以便在新的资源、工具和软件可用时接收更新。操作很简单，只需要1分钟。

您可以开始跟踪此产品，以便在新的资源、工具和软件可用时接收更新。操作很简单，只需要1分钟。

您可以开始跟踪此产品，以便在新的资源、工具和软件可用时接收更新。操作很简单，只需要1分钟。

Invalid code, please check the code sent to your email address and validate again. In case you did not receive any code please select 'I did not receive code'

您可以开始跟踪此产品，以便在新的资源、工具和软件可用时接收更新。操作很简单，只需要1分钟。

请查看我们的隐私声明，该声明描述了我们如何处理您的个人资料信息以及如何维护您的个人数据保护权利

现在，您订阅了
- L4984D

You can re-use the validation code to subscribe to another product or application.

Sorry, there was a problem on our servers. Please try again.