点击前往正文

STTS751

NRND
储存到myST

2.25 V低电压本地数字温度传感器

下载数据手册
Order Direct

本产品状态为

NRND
. 

我们推荐您使用以下产品作为替代: 

STTS22H

产品概述

描述

The STTS751 is a digital temperature sensor which communicates over a 2-wire SMBus 2.0 compatible bus. The temperature is measured with a user-configurable resolution between 9 and 12 bits. At 9 bits, the smallest step size is 0.5 °C, and at 12 bits, it is 0.0625 °C. At the default resolution (10 bits, 0.25 °C/LSB), the conversion time is nominally 21 milliseconds.

The open-drain EVENT output is used to indicate an alarm condition in which the measured temperature has exceeded the user-programmed high limit or fallen below the low limit. When the EVENT pin is asserted, the host can respond using the SMBus Alert Response Address (ARA) protocol to which the STTS751 will respond by sending its slave address.

The STTS751 is a 6-pin device that supports user-configurable slave addresses. Via the pull-up resistor on the Addr/Therm pin, one of four different slave addresses can be specified. Two order numbers (STTS751-0 and STTS751-1) provide two different sets of slave addresses bringing the total available to eight. Thus, up to eight devices can share the same 2-wire SMBus without ambiguity, thereby allowing monitoring of multiple temperature zones in an application.

The two-wire interface can support transfer rates up to 400 kHz.

  • 所有功能

    • Operating voltage 2.25 V to 3.6 V
    • Operating temperature –40 °C to +125 °C
    • Programmable
      • 10 different conversion rates 0.0625 to 32 conversions/sec. 1 conversion/sec. - default
      • 4 different resolutions 9-bit (0.5 °C/LSB) to12-bit (0.0625 °C/LSB) 10-bit (0.25 °C/LSB) - default
    • Low supply current
      • 50 μA (typ) for 8 conversions/sec.
      • 20 μA (typ) for 1 conversion/sec.
      • 3 μA (typ) standby
    • Accuracy
      • ±0.5 °C (typ) 0 °C to +85 °C
      • ±0.5 °C (typ) –40 °C to +125 °C
    • One-shot mode for power saving
    • Fast conversion time 21 ms (typ) 10-bit
    • Pull-up resistor value allows single pin to select one of four slave addresses
    • Supports 400 kHz serial clock
    • SMBus 2.0 compatible
      • SMBus ALERT (ARA) support
      • SMBus timeout
    • RoHS/green

您可能还会喜欢...

C-Driver-MEMS

面向MEMS运动和环境传感器的标准C跨平台驱动程序

STEVAL-MKI198V1K

基于STTS751的温度传感器套件

STDES-IDS002V1

由PV电池供电的自主无线多传感器节点

特别推荐

您知道吗？

Please provide email

Please enter code

Congratulations!

Simple subscription

Congratulations!

x

您可以开始跟踪此产品，以便在新的资源、工具和软件可用时接收更新。操作很简单，只需要1分钟。

您可以开始跟踪此产品，以便在新的资源、工具和软件可用时接收更新。操作很简单，只需要1分钟。

您可以开始跟踪此产品，以便在新的资源、工具和软件可用时接收更新。操作很简单，只需要1分钟。

Invalid code, please check the code sent to your email address and validate again. In case you did not receive any code please select 'I did not receive code'

您可以开始跟踪此产品，以便在新的资源、工具和软件可用时接收更新。操作很简单，只需要1分钟。

请仔细阅读我们的隐私声明，了解我们将如何处理您的个人资料信息，以保障您个人数据的安全。

现在，您订阅了
- STTS751

You can re-use the validation code to subscribe to another product or application.

Sorry, there was a problem on our servers. Please try again.
The current status of a product:
Active: Product is in volume production
Evaluation: Product is under characterization. Limited Engineering samples available
Preview: Product is in design stage
Target: Product is in design feasibility stage.No commitment taken to produce
Proposal: Marketing proposal for customer feedback.No commitment taken to design or produce
NRND: Not Recommended for New Design.Product is in volume production only to support customers ongoing production.Marketing description of the package type.The RoHS status of a product:
ECOPACK 1: Initial grade to identify European RoHS compliant products.
ECOPACK 2: New grade to identify brominated chlorinated and antimony oxide flame retardant free products.
ECOPACK 3: Halogen free RoHS exemptions free products.
(*): ECOPACK 2 version available upon request.
(**): Some versions still existing in ECOPACK 1 or not compliant.Longevity Commitment in yearsLongevity Starting DateThe current status of a product:
Active: Product is in volume production
Evaluation: Product is under characterization. Limited Engineering samples available
Preview: Product is in design stage
Target: Product is in design feasibility stage.No commitment taken to produce
Proposal: Marketing proposal for customer feedback.No commitment taken to design or produce
NRND: Not Recommended for New Design.Product is in volume production only to support customers ongoing production.Budgetary PriceMarketing description of the package type.Storage method used to contain product.Main country of assembly or fabrication of the product.ECCNs are five character alpha-numeric designations used on the Commerce Control List to identify dual-use items for export control purposes. ECCNs are five character alpha-numeric designations used on the Commerce Control List to identify dual-use items for export control purposes.The value as specified by level (minTypMax) of the ambient temperature (in Cel) in which this item was designed to operate.The value as specified by level (minTypMax) of the ambient temperature (in Cel) in which this item was designed to operate.The value as specified by level (minTypMax) of the ambient temperature (in Cel) in which this item was designed to operate.