L5964 | 产品 - 意法半导体

概述

开始

Partner products

銷售公文包

产品概述

描述

L5964 is a dual step-down switching regulator with internal power switches and a low drop-out linear/standby regulator. All the regulators have independent supply voltages, enables, power goods and thermal protections.

The switching regulators have selectable voltage supervisors and power goods, and selectable current limits. The LDO has power good and fixed current limitation.

The two DC-DC converters can work in free-run condition, with frequency selectable between two values, 270 kHz or 2.2 MHz, or synchronize themselves to an external clock (SYNCIN pin). They are 180° out of phase, while the synchronization output signal (SYNCOUT pin) is 90° out of phase with the first regulator. The phase shift simplifies the use of two ICs in the same application (4 DC/DC regulators).

DC-DC1 and DC-DC2 current limits can be independently set through the pins OCPSET1 and OCPSET2 respectively. Two current limits are available, 2 A (1.7 A min) and 4.5 A (3.7 A min).

For operation >2 A, Schottky diodes vs ground should be placed as close as possible to PHASE1/2 pins. These diodes should sustain 20 V, 2 A at room temperature and have less than 0.5 V forward voltage.

The high operating frequency allowed by the synchronization input helps to reduce AM and FM interferences and grants the use of small and low cost inductors and capacitors.

The L5964 can manage the microcontroller supply. A configurable reset output and a configurable watchdog input are available.

This IC finds application in the automotive segment, where load dump protection and wide input voltage range are mandatory. L5964 has been qualified for car passenger cars, with a standard 14 V battery. The total quiescent current, when both DC/DCs and LDO are disabled, is less than 10 µA.

The product is available in LQFP64 exposed pad up and in VQFPN48 slug down package. The slug, whenever possible, has to be connected to the ground plane.

所有功能
AEC-Q100 qualified

Two step-down synchronous switching voltage regulators with internal power switches:

Output voltage selectable by external divider (feedback voltage at 0.9 V)

Minimum and maximum output is limited by minimum and maximum duty cycle

Internal high-side/ low-side NDMOS

270 kHz and 2.2 MHz selectable free-run frequencies

125 kHz < f < 2.3 MHz synchronization range at SYNCIN pin

Programmable current limits at 2 A and 4.5 A (> 2 A requires the addition of external schottky diodes)

Independent hardware enabling pins

Independent supply inputs

180° phase shift between outputs

Synch out 90° phase shift vs DC-DC1

Programmable switching frequency divider by 1, 2, 4, 8 between the two regulators

Independent voltage supervisors/power-goods with selectable thresholds through external pin:

two available thresholds for UV/OV/PG signals: 90-120-95% or 80-110-85% (output voltage percentage)

Soft-start, thermal protection

One standby/linear regulator:

Output selectable with external resistor divider till 10 V

Soft start, hardware enable pin

250 mA maximum current capability

Standby operative mode

Programmable power good thresholds (85% or 95% output voltage percentage)

Thermal protection

Microcontroller reset with programmable duration, activated by output under voltage or watchdog fault
External High Side Driver enable pin

One integrated window watchdog (5 ms ≤ window ≤ 50 ms, with ± 20% tolerance)

Short circuit protected outputs

Low external components number

Thermal shutdown junction temperature 150°C
阅读更多信息阅读较少信息